You may want to warn users of any impending offline volumes and iSCSI disconnections before resetting the password.The active control module is indicated by the green control module status LED labeled ACT.
Equallogic Ps4100 Battery Status Failed Serial Port OnThe status LEDs are located on the controllers sometimes on the left side or next to the serial port on other controllers. Volumes with data located on the member will be offline and iSCSI connections to those volumes will be lost until the member is restarted. This is to ensure that, while you are setting password-recovery mode on one controller, the other controller doesnt run past us and start the array up. Controllers just have to be removed a little so they dont make contact any more to be disabled. This will halt the boot process and allow you to enter commands to the boot monitor. After a short pause, the following message should appear: WARNING:Password recovery mode Temporarily resetting grpadmin password. Equallogic Ps4100 Battery Status Failed Manual Or UseUse the procedure described in the Modifying Accounts section in the Group Administration manual or use the following command. If the password recovery mode message does not appear, the password reset procedure did not succeed (for example, because you did not enter the CFE commands exactly as shown). In this case, allow the member to completely start up, and then retry the password reset procedure, shutting down the member and following the steps above. Within one minute, you should see a console message, indicating that the secondary control module is operational. ![]() He has over 28 years of industry experience with a key focus on data management, availability and cyber security. He is a veteran vExpert, Cisco Champion and holds several other certifications.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |